Maple fudge | Easy recipe | No boil | Cooking with my kids (2024)

FAQs

Should you stir fudge while it's boiling? ›

Avoid Stirring Once the Mixture Comes to a Simmer

Another key part of a successful fudge texture is when you stir the mixture. Stirring the sugar and milk during the initial stages of cooking allows the sugar to dissolve. However, once the mixture comes to a boil, it's time to put the spoon down.

To fix oily, hard or grainy fudge, scoop the fudge back into a pot with about a cup of water. Cook it over low heat until the fudge dissolves. Then bring the fudge back up to the temperature specified in the recipe and follow the remaining steps. The flavor may be slightly diluted, but the texture will be improved.

By letting the fudge cool without stirring, you avoid creating seed crystals. Stirring would help sucrose molecules "find" one another and start forming crystals. Stirring also introduces air, dust, and small dried bits from the walls of the saucepan—all potential seeds for crystal formation.

Too cooked

The result is hard and brittle fudge. To save the fudge, put it in a saucepan with 45 to 60 ml (3 or 4 tbsp.) of 35% cream and bring to a boil, stirring until the sugar is completely melted. Then let it boil without stirring until the thermometer reaches 114 to 115 °C (237 to 239 °F).

The trick to good homemade fudge is to cook the ingredients to the right temperature to form a sugar syrup, and cool the mixture properly so the texture of the fudge turns out smooth and firm, but soft enough to cut.

Fudge usually behaves this way when it's not cooked to a high enough temperature (due to oversight or a faulty candy thermometer). If your fudge is tough, hard, or grainy, then you may have made one of several mistakes: You may have overcooked it, beaten it too long, or neglected to cool it to the proper temperature.

So, the key to smooth yet firm fudge, pralines, and fondant is to first bring the mixture to a high enough concentration and then let it cool off somewhat before starting to stir. And once you do start to stir, stir fanatically and without stopping for the finest, creamiest texture.

If you didn't reach the correct temperature during the cooking process, it might not set properly. Use a candy thermometer to ensure that you reach the recommended temperature. Overcooking or Undercooking:Solution: Cooking the fudge for too long or too short a time can affect its texture.

Candy that isn't cooked long enough will end up too soft; overcooking makes fudge crumbly or hard. High-quality fudge has many small crystals. If the process of crystallization begins too early, fewer crystals form and they become much larger.

What is a soft boil for fudge? ›

According to most recipes, the ingredients of fudge are cooked to what is termed in kitchen parlance the soft ball stage, that point between 234 and 240 °F (112 and 115 °C) at which a small ball of the candy dropped in ice water neither disintegrates nor flattens when picked up with the fingers.

If the fudge is very soft and slightly chewy then it is possible that it did not quite cook to soft ball stage and next time the mixture should be cooked to a slightly higher temperature (soft ball is 112-116c/235-240F and a sugar or candy thermometer can help).

If it's overcooked (resulting in grainy fudge) or undercooked (resulting in poor setting) all you really need to do is add a bit of cream, reheat the fudge to the target temperature, and let it set again.

There are 2 reasons that fudge will crumble: overcooking & having an undissolved sugar crystal in the mixture. That undissolved crystal will cause the dissolved sugar to recrystalize (think rock candy).

Pour the mixture over the chocolate, being sure to shake, not scrape, the mixture from the pot. Set aside to cool for 10 to 12 minutes. (This prevents a grainy consistency.) Using the clean wooden spoon or a standing mixer on low speed, stir or beat the mixture until the chocolate is completely melted and incorporated.

Keep a bowl of water inside the microwave along with the fudge to create moisture for the pieces to inhale. Next, microwave the fudge pieces for just 10 seconds. So it will become soft but it won't have the correct consistency as before.

Don't panic if your fudge is grainy, nothing is lost it just requires some more work. Pop the grainy fudge back into the pan along with some water and a little cream and melt the fudge back down to a liquid and re-boil it to temperature.

If the fudge is very soft and slightly chewy then it is possible that it did not quite cook to soft ball stage and next time the mixture should be cooked to a slightly higher temperature (soft ball is 112-116c/235-240F and a sugar or candy thermometer can help).

The main reason is that your Fudge has not reached the optimum temperature. If your mixture only reaches 110 or 112 degrees Celsius it will always be soft. That's why we recommend investing in a sugar thermometer. Another reason your Fudge is not setting is that the ratio of liquid to sugar is too high.