Petkit Pura X Troubleshooting (2024)

FAQs

How to factory reset Pura X? ›

Reset button: Use a pen or other pointed object to press reset button, and hold it down for 10 seconds to restart the device.

Maintenance mode: Click it to enter the maintenance mode to leave the cylinder opening facing up and staying still to clean the device and add cat litter with ease. Empty cat litter: Click it to empty the remaining cat litter in the cylinder after installing the cat litter remover.

Make sure the diffuser is plugged into an outlet receiving power. If that outlet does not receive power, move it to another outlet, and press the reset button again.

To manually control fragrance without the Pura app, push the button once for each intensity level (high, medium, low, off).

PURA MAX is compatible with all kinds of clumping cat litter such as clay litter, tofu litter, mixed litter, and more. We strongly recommend using the PETKIT Everclean Flushable Cat Litter, which consists of all-natural ingredients, clumps fast, and is FDA approved.

This automatic litter box system uses ScoopFree premium blue crystal cat litter trays that are intended to last approximately 30 days. The trays use dye-free silicon crystal cat litter that absorbs urine and dries solid waste.

To activate the manual-cleaning mode, simply tap the "Clean" button via the PETKIT app or press the button on the Puramax to clean the cat litter box.

Experts recommend cleaning the litter box monthly, but maybe more frequently depending on the number of kitties, the type of litter, your cat's output and health, and your preferences.

How do I factory reset my Pura diffuser? ›

Press and hold the reset button until the nightlight starts breathing blue. Click Continue in your app to follow the remaining steps. Hard Reset1. Open your Pura app and click on the three lines above the diffuser you'd like to reset.

EdgeRouter to factory defaults: Runtime reset (recommended) The EdgeRouter should be running after bootup is complete. Press and hold the Reset button for about 10 seconds until the eth4 LED starts flashing and then becomes solidly lit.

Power on the Pura Max litter box and when it's operational, perform a manual reset by holding the OK button for about two seconds until it starts leveling and calibrating (step 7 from option 1). Wait until reset is completed.

Power-on reset Disconnect power from the EdgeRouter. Press and hold the Reset button while connecting power to the EdgeRouter. The port LEDs will light up in sequential order. Keep holding the Reset button until the LED on the last port starts flashing, and then release the button.